ApplianceErrors.com
🫧

Miele Washing Machine Error Codes

20 error codes with causes and step-by-step fixes

Your Miele washing machine uses 20 distinct error codes to flag faults before they turn into a full breakdown. The most common cluster around control (5), sensor (4), motor (3). Of these, about 20 can usually be cleared at home without a technician, while 11 point to more serious faults that may warrant a professional. Typical repair costs on this appliance run from $0 for simple DIY fixes up to $600 for professional component replacement.

Find your code in the table below for its exact meaning, the most likely causes ranked by how often they're the culprit, a step-by-step fix, the parts you may need, and a clear call on when it's worth phoning a repair pro.

Code Meaning
F11 Pump fault β€” water not draining
F19 Drain time exceeded β€” slow or failed drain
F16 Water protection system activated β€” flood protection triggered
F53 Motor fault β€” drive motor failure
F31 NTC temperature sensor fault
F1 NTC temperature sensor short-circuited
F2 NTC temperature sensor open-circuited
F15 Hot water intake fault
F20 Heating fault β€” water not reaching target temperature
F34 Door lock fault β€” door will not lock
F35 Door unlock fault β€” door will not release
F39 Electronic unit fault β€” main control failure
F41 Faulty electronic memory β€” incorrect data
F43 Appliance model not programmed
F45 Defective Flash RAM β€” incorrect data supplied
F50 Drive fault β€” motor or drive electronics
F51 Pressure/level sensor fault
F56 Spin fault β€” final spin speed below 400 rpm
F63 Water path control unit fault
F65 Drum lighting cap missing

⚠️ Serious Errors β€” Act Quickly

F11
Pump fault β€” water not draining
The control detected that water was not pumped out within the expected drain tim…
F19
Drain time exceeded β€” slow or failed drain
F19 fires when the control board times the drain phase and the water level fails…
F16
Water protection system activated β€” flood protection triggered
F16 fires when a float switch in the machine's base tray detects standing water,…
F53
Motor fault β€” drive motor failure
F53 fires when the motor control electronics detect an out-of-range condition in…
F20
Heating fault β€” water not reaching target temperature
F20 fires when the control board does not see the wash water reach its programme…
F39
Electronic unit fault β€” main control failure
F39 fires when the washer's main electronic unit runs its internal self-check an…
F41
Faulty electronic memory β€” incorrect data
F41 fires when the control's self-check reads invalid or unreadable data from it…
F43
Appliance model not programmed
F43 fires when the control electronics contain no valid model identification cod…
F45
Defective Flash RAM β€” incorrect data supplied
F45 fires when the control board's self-check finds that its Flash RAM is return…
F50
Drive fault β€” motor or drive electronics
F50 fires when the control board loses valid feedback from the drive system β€” th…
F63
Water path control unit fault
F63 fires when the control board cannot correctly drive or confirm feedback from…

No Code on the Display?

Start from what the washing machine is doing instead: