How to Reset a Bosch Dishwasher
Hold Start ~3–5 seconds to cancel/reset a cycle; E15 clears only when the base pan dries.
Reset Steps
- 1
Press and hold Start (labeled Reset on many panels) for 3–5 seconds, then close the door — the unit pumps out and resets.
- 2
For persistent codes, switch the breaker off for 60 seconds.
- 3
E15: tip the unit forward to empty the base pan, dry it, fix the leak source, then reset.
💡 Good to know: If the drain pump runs continuously even with the door open, that is the E15 flood-switch state — the pan is wet.
If the Code Comes Back
A code that returns after a reset means the underlying fault is still present. Look up your exact code for its causes and step-by-step fix:
E15 Leak protection activated — water detected in base tray E24 Drain blocked — dishwasher not draining E25 Drain pump or filter blocked — drain impeller obstructed E01 Heating element or NTC sensor failure — water not heating E09 Heating circuit failure — heater not functioning E05 Water shortage — insufficient water entering dishwasher E22 Residual water in the sump — filter or impeller area blocked E04 Water flow sensor fault — fill volume not being measured
Frequently Asked Questions
How do I clear E15 on a Bosch dishwasher? +
Pull the unit out and tip it forward ~45° to drain the base pan, dry it thoroughly, and fix the leak source. E15 cannot be bypassed — the float switch blocks operation while the pan is wet.
How do I reset a Bosch dishwasher mid-cycle? +
Hold the Start/Reset button for 3–5 seconds with the door closed enough to engage. The unit drains for about a minute and returns to standby.