How to Reset a Electrolux Washing Machine
60-second power-cycle clears soft faults.
Reset Steps
- 1
Power off, unplug 60 seconds.
- 2
Restore and run Rinse & Spin.
- 3
Returning codes are real — follow the code's fix steps.
💡 Good to know: Door-lock faults may hold the door for several minutes after power-off before the lock releases — don't force it.
If the Code Comes Back
A code that returns after a reset means the underlying fault is still present. Look up your exact code for its causes and step-by-step fix:
E20 Drain error — water not draining E10 Water inlet error — no water detected E40 Door not closed or door lock failure E50 Motor failure E90 Wiring harness fault — communication error E11 Long fill time — washer not filling during the wash phase E13 Water leak detected — level dropping when it should not E21 Drain error — water not pumping out fast enough
Frequently Asked Questions
How do I clear E20 on an Electrolux washer? +
Clean the drain pump filter behind the lower front access panel (towels down — it holds water), check the drain hose for kinks, then power-cycle 60 seconds. E20 returns until drainage is actually restored.