WDF520PADM Error Codes — Whirlpool Dishwasher
🏷️ Model: WDF520PADM 📅 Production: 2014–2020 🍽️ Type: Dishwasher
Workhorse budget dishwasher. Codes are read as blink patterns on the Clean light or shown as F-E pairs on display models.
Most Common Codes on the WDF520PADM
All Other Whirlpool Dishwasher Codes
The WDF520PADM can also display any of the standard Whirlpool dishwasher codes:
F3E1 Thermistor failure — low resistance reading F3E2 Thermistor failure — high resistance / open circuit F6E1 Water heating failure — not reaching target temperature F7E1 Circulation pump motor error CAL Calibration needed — sensor recalibration required F1E1 Control board / thermistor stuck — electronic control fault F2E1 User interface stuck key — button held or touchpad fault F5E1 Door switch fault — control cannot confirm door state F5E2 Door will not latch / lock — latch mechanism fault F6E3 No water detected — inlet / fill problem F8E1 No / low water fill — slow or insufficient fill F9E2 Diverter motor fault — diverter stuck or not detected F1E2 Main control board / sensor circuit fault — electronic control failure F8E2 Water inlet valve electrical fault — valve circuit problem
💡 Tip: Your model's serial sticker (door frame, rim, or back panel) confirms the exact
model number. Codes can differ between revisions of the same model line — if a code on your display
isn't listed here, check the
full Whirlpool dishwasher code list.