How to Reset a LG Dishwasher
Breaker off for 60 seconds resets the control. AE leak codes need a dry base pan to clear.
Reset Steps
- 1
Switch off the dishwasher breaker (or unplug under the sink) for 60 seconds.
- 2
Restore power and run a short cycle.
- 3
AE codes: dry the base pan first; the float must drop before the code clears.
💡 Good to know: Repeated AE with a dry pan usually means a slow door-gasket or sump seal leak that only appears mid-cycle — run a cycle with the kick plate off and watch with a flashlight.
If the Code Comes Back
A code that returns after a reset means the underlying fault is still present. Look up your exact code for its causes and step-by-step fix:
AE Leakage detected — water found in base tray OE Drain error — dishwasher not draining IE Water inlet error — not filling with water FE Water overflow — overfill protection triggered HE Heater failure — water not heating tE Temperature sensor failure LE Leakage detected — flood protection activated CE Motor/pump over-current error
Frequently Asked Questions
How do I clear the AE code on an LG dishwasher? +
AE means the leak float in the base pan tripped. Tip/towel the pan dry, find the source of the water, then power-cycle. The code clears once the float drops.