How to Reset a GE Appliances Dishwasher
Cancel first, then breaker power-cycle for 60 seconds.
Reset Steps
- 1
Press Start/Reset (or Cancel) and let the unit pump out for 2 minutes.
- 2
If the code persists, switch the breaker off for 60 seconds and restore.
- 3
Run a 1-hour wash to confirm.
💡 Good to know: FL flood codes require the base pan to dry before they clear, just like other brands' leak sensors.
If the Code Comes Back
A code that returns after a reset means the underlying fault is still present. Look up your exact code for its causes and step-by-step fix:
C5 Drain failure — dishwasher not draining FL Flood switch activated — water in base tray C4 Wash motor failure — circulation pump not running PF Power failure — cycle interrupted by power outage OE Drain error — not draining properly C3 Control board failure C7 OWI sensor failure — optical water indicator fault HO Water not hot enough — incoming water temperature too low
Frequently Asked Questions
What does HO mean on a GE dishwasher? +
Heating delay — the dishwasher is waiting for water to reach temperature. It is status, not a fault. If cycles run hours long, check inlet water temperature (should be ~120°F) and the heater.